联系我们
邮箱登陆:
账号:
密码:
忘记密码?
产品展示

螺翼式冷、热水表

      产品名称:螺翼式冷、热水表
       产品型号:LXL-C/E型                                                                          
        产品系列:机械式水表
        使用范围:用于测量流经自来水管道的水体积总量的流量测量仪表

 

 
结构与用途 Structure and Use
 

(1)本水表是用于计量流经管道自来水或中水的体积总体量的流量测量仪表,适用于单向水流的自来水、井水、纯净水、中水等计量,该水表具有流通能力大,压力损益小,读数清晰直观,使用寿命长等特点。
(2)水压不大于1MPa      

(3)冷水水表水温不超过40℃且不低于0℃      

(4)冷水水表水温不超过90℃

 (1)This meter use to measure the mass of volume of tap water through pipe, suit to measure flux tap water, well water, pure water, and intermediate water in single direction. This meter has huge circulation, small pressure lost, clear number show and long work life feature.
 (2)The water pressure should under 1MPa      

(3)The cold water should under 40℃ and no less than 0℃
(4)The heat water meter should under 90℃

 
主要术技指标 Main parameter
 
 
水表型号规格
lever model
公称口径
Rated bore
特性流量
Feature flux
最大流量
Max flux
额定流量m3/h
Rated flux
最小流量
mix flux
始动流量m3/h
beginning flux
最小示值
Min show unit
最大示值
Max show unit
LXS-50 50 30 15 10 0.40 0.09 0.01 99.999
LXS-80 80 70 35 22 1.10 0.30 0.01 999.999
LXS-100 100 100 50 32 1.40 0.40 0.01 999.999
LXS-150 150 200 100 63 2.40 0.55 0.01 999.999
 
水表型号规格
lever model
公称口径
Rated bore
计量等级
account grade
公称流量
rated flux
最小流量
mix flux
分界流量m3/h
dividing flux
最小示值
Min show unit
最大示值
Max show unit
LXL-80 80 A
B
40 3.20 12.0 0.01 1,000,000
1.20 8.0
LXL-100 100 A
B
60 4.80 18.0 0.01 1,000,000
1.80 12.0
LXL-150 150 A
B
150 12.00 45.0 0.01 1,000,000
4.50 30.0
LXL-200 200 A
B
250 20.00 75.0 0.1 10,000,000
7.50 50
(一)被测水温不能超过30℃
(二)最大允许工作压力(公称压力)为10Kgf/cm2(98×104Pa)  
(三)在最大流量时,水表的压力损失不超过为1Kgf/cm2(98×104Pa)  
(四)从最小流量量至不包括分界流量的低区的示值误差限:±5%
      从包括分界流量至包括最大流量的高区的示值误差限:±2%
 
(一)The temperature of the water can't pass 30℃
(二)The rated pressure:10Kgf/cm2(98×104Pa)
(三)The pressure lost in the water meter in Max flux ≤1Kgf/cm2(98×104Pa)
(四)The show number error range form mix flux to the low district:±5%
      The show number error range form dividing line flux to the high district:±2%
 
注:(1)公称流量是水表在规定误差限内允许长期工作的流量。
      (2)始动流量是水表开始连续指示时的流量,此时水表不计示值误差。
      (3)最小流量是水表在规定误差内使用的下限流量。低于最小流量时水表不能准确计量。
      (4)最大流量是水表在规定误差限内使用的上限流量。在最大流量时,水表只能短时间工使用不至损坏。
Note:(1)Rated flux is the permitted flux in the long work situation for the water meter.
         (2)Beginning flux is the flux at the moment the meter open, and this time, the meter can't accout the show error.
         (3)The Mix flux is the permitted Mix flux for the meter, if the flux is lower than this number, the meter will not to account correctly.
         (4)The Max flux is the highest flux for the meter in the rated error, at the max flux the meter only work in a short time and not to broken.

 

下一篇:没有了